Power864 2 wire smoke reset trouble

[pitref75]

Hi I'm newbie

I already found my first  question in forum for 2 wire smoke with power864 need remove con1 or JP1 (nothing in installation Manuel PC5020 V3.2?)

Panel 864 with 2 Partition, 1 House 2 Garage, all other partition set off
all zones ( + keypad (1) are full.
Add 2 smoke FSA-210BST + 2.2k eol  (house)

Aux+ and PGM2
programming 009 option 4 pgm2
                    502 default
                    552 partition 1 only

Everything look ok , I test smoke (hold 5sec) smoke trip (buzzer) panel go in fire alarm.

Trouble is for resetting

 enter code (LCD5500Z)
 hold reset or *72 (pgm i\o in progress...)
      smoke reset (buzzer stop) but panel still in alarm.
 need to go on garage enter code to stop alarm or switch partition on keypad ?

 Very no practical in false alarm condition !

It is normal to need  enter code in all active partition ? or programming error ?

look all programming with dls2002 but find nothing ?


                

[Ken_in_Pittsburgh]

Welcome to the forum.

    I'm not sure I completely understand your question. Entering your code for the partition that is in alarm should end the alarm. If the smoke detector is in the house (Partition 1), and the keypad in the house is assigned to Partition 1, then entering your code at that keypad should end the alarm. What programming, if any, did you do in section 000?

                                           --Ken

[pitref75]

Partition 1 (house)
keypad LCD5500Z V3.1          section 000 default 18 03 04 06 14 16
Partition 2 (garage)
Keypad old PC5508(no zone) section 000 default 21 03 04 06 14 16

I have IP board Envisa|ink 2*S enroll like pc5400

Receive SMS for fire alarm partition 0
Receive SMS for PGM2 reset partition 1

but panal stay in alarm condition for (bell timeout) or enter my code on both keypad  for each partition and pmg2 is only  attribuate to partion 1 ?

I really don't know if is normal but very not practical no way for next toast burn for my girlfriend or anyone else go outside by -20C to enter user code on garage keypad.
 
I ask professional DSC installer no answer no clue ?

If somebody can help thanks, I try many setting.
With DLS2002 or direct keypad programmation.

Next move ,  buy 2 fsa-410 bst to replace 2 wire smoke , merge 2 zones or add PC5108 board.