Adding an entry delay

[hotazguy]

I have an A*T Safeguard Pro 3000 alarm system.  The control panel is, I think, a 6150.  It's programmed now with an entry delay for the house front door.  I had an extra wireless magnetic door switch so the installer put it on a shed door and it was programmed without an entry delay.  He assigned it number 12 on the system. 

I just built a garage and moved the shed magnetic door switch to the garage "man" door so the garage would be protected instead of the shed.  I just installed a garage door opener and now need to program the garage "man" door with an entry delay so that when I drive in, park, and exit through the "man" door I don't set off the alarm.

How do I do this? 

[SmithWesson]

Your going to have to use a 6160 for zone programming. You cannot do it with a 6150.

[hotazguy]

No, I don't need zone programming.  The wireless switch #12 was already in use on the shed.  I moved it to the garage.  All I want to do is add a delay to it, just like the front door.  Nothing more, nothing less.

How do you do it?

[rvt]

Hi and welcome
S&W is correct unless you are a pro and know what you are doing you can messs all the programing ,, you need to change this zone to a zone type 1 from probally what is probally now a zone type 3 ( perimeter )  1 is an e/e delay

[hotazguy]

Super.  Please walk me through the steps of doing so.

Thanks.

[SmithWesson]

do you have a 6160 keypad and the installer code so that you can get into zone programming?
If so,
installer code
800
*56
*
12
screen now shows 03 perimiter
01
* and *again until you get back to the zone screen showing 13
00
*
*
99
Done

Your zone 12 is now entry/exit